Operation - Reloop RMP-1 scratch Operation Manual

CAUTION:
Do not try to close the CD tray manually - you could break the mechanism.

OPERATION

1. CD Drive
2. Play/Pause button
NOTE:
Your CD player goes into Auto-Cue mode after being switched on.
automatically set on the first signal of a music track.
3. Cue button
To set a Cue Point, follow either of the following two options:
NOTE:
When pressing the Cue button while in Play mode when no Cue Point has
been set, the player returns to the start of the track and goes into Pause
mode (Auto-Cue). The player saves the Cue Point which can be prompted
with the Cue button for a single track only. When changing to another track,
the previous Cue Point will no longer be saved.
4. Track Wheel
5. Search Wheel
20
For information regarding the drive, please refer to the above installation
notes. ( see F)
Press the Play/Pause button -2- to start play mode. Press again to activate
Pause mode.
see also item 8 or item 11/O. In this DJ-friendly mode, the Cue Point is
A Cue Point is a self-defined starting point, usually at the beginning of a beat.
When activating the Cue button -3- the CD player interrupts playing the track
and returns to the last set Cue Point.
I.) Search the desired Cue Point using the Jog Wheel -18- or the Search
Wheel -5- while in Pause mode. You will access the Frame Search mode
(fragmented repeats =1/75 minute) and can precision-set your Cue
Points. Then press the Play/Pause button -2- to save the Cue Point. The
player returns to Play mode.
II.) While in Play mode, press the Loop IN button -12- at the desired point to
save the Cue Point. The player remains in Play mode. With a little
practice, this is a faster way to set the desired Cue Point.
Press the Cue button -3- for the player to return to the Cue Point and go into
Pause mode. By pressing and holding the Cue button you will return to Play
mode until you release the button again. The player will then return to the
Cue Point and go into Pause mode. Press the Play/Pause button to
permanently return to Play mode.
Use the Track Wheel -4- to select tracks. Press and turn the Track Wheel-4-
at the same time to move in increments of ten through the selection of
tracks.
Turn the Search Wheel -5- to advance the track clockwise and counter-
clockwise. The wheel features four different search speeds. The faster the
wheel is turned in either direction, the faster you will advance. While in Pause
mode, frame-search the track passages. The current frame (=1/75 minute) is
constantly repeated.