Using The Unit As A Public Address System; Led Light Shows; Dancing Water Led Light Show - Karaoke Night KN275 User Manual

Cd+g karaoke machine with dancing water display and led light show
Table of Contents

Advertisement

5. Turn on your microphone and start singing. Adjust the MASTER VOLUME and/or MIC
VOLUME if necessary.
6. You may also use the BALANCE and ECHO CONTROLS to enhance your singing
experience.
7. Turn off both devices after use.
NOTE: Once the AUX IN jack has been plugged into, the unit automatically enters the AUX
mode no matter what position the Function Selector is in. Remember to disconnect the Aux In
cable from the unit after use in order to listen to the CD or USB input again.

USING THE UNIT AS A PUBLIC ADDRESS SYSTEM

This unit can also be used as a PA (Public Address System).
Note: To prevent feedback or whistling from occurring, please be sure that the microphone is
not held too close to unit's speaker.
1. With unit stopped at CD or USB mode, unplug any 3.5mm audio cable (not included)
connected to the AUX IN JACK previously.
2. Turn on your MICROPHONE (one included) and start your performance. Adjust the
MASTER VOLUME, MIC VOLUME and ECHO control if necessary.
 The LED light shows inside the speaker and in the lower corners of the unit are created
automatically based on the music source being played at the time
 To turn off the LED light show, press and hold the LIGHT SHOW button.
 To turn on the LED light show, press LIGHT SHOW button again.
Note: If the brightness is glaring, turn on room lights or turn off LED light show
 The dancing water LED light show is created automatically based on the music source
being played at the time
 To turn on the Dancing Water LED light show, slide the DANCING WATER switch to ON
position.
 To turn off the Dancing Water LED light show, slide the DANCING WATER switch to OFF
position.
 

LED LIGHT SHOWS

DANCING WATER LED LIGHT SHOW

14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents