Resetting The Unit; Care And Maintenance; Troubleshooting Guide - Karaoke Night KN355 User Manual

5. Press PLAY/PAUSE button when you have completed programming to start playing. You are now
ready to start singing along.
6. Press STOP button twice or open the CD COMPARTMENT COVER to clear all the programmed entries.
USING MICROPHONES/ECHO/BALANCE/AVC/DIGITAL KEY CONTROL
•
MICROPHONE : When either one or two Microphones are plugged into the MIC 1 jack / MIC 2 jack, their
output is mixed with the playback from CD/CD+G discs.
•
MIC VOLUME:
microphone (singing) levels.
•
ECHO : Adjust ECHO to add depth and richness to vocals.
•
BALANCE : Adjust BALANCE for balance between the pre-recorded singer's voice and the music if you
are using a multiplex karaoke disc.
•
AVC : Press the AVC (Automatic Voice Control) button to ON if you want the original singer's voice to stop
while you are singing. The original singer's voice will resume immediately when you pause your singing.
•
DIGITAL KEY CONTROL: Adjust accordingly to be able to sing at your desired pitch.
If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down
automatically. If this occurs, simply disconnect the AC Adapter. Wait for at least 3 minutes and then setup the
unit again as if you were using it for the very first time.
1. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
2. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
3. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or
motors.
4. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play
at all, its bottom surface may require cleaning. Before playing, wipe the disc from the
center outwards with a good soft cleaning cloth
If you experience difficulties in the use of this music system please check the following or call 1-800-777- 5331
for Customer Service.
PROBLEM
No power when
plugged in
No sound
CD PLAYER does
Adjust corresponding MIC VOLUME knob for best balance between playback and

RESETTING THE UNIT

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
AC adapter is not plugged into the
AC outlet.
The AC outlet may not have
power.
Master volume control is set to
minimum.
Volume control on TV set/PA
system is set to minimum.
TV set/PA system power is OFF.
Disc inserted upside down.
Insert the AC adapter into the AC outlet.
Check the outlet with a working lamp or other
electrical appliance.
Turn up the master volume.
Turn up the volume of the TV/PA system.
Turn on the power at TV/PA system.
Insert disc correctly.
9
SOLUTION