Table of Contents
Advertisement
Installation
ö
Water drain
§ §
ƒUHook over the edge of a sink using the plastic hose hanger supplied with the machine.
ƒUMake sure there are no kinks in the hose and that it is no crushed.
Secure the hose so that it can not be dislodged while the appliance is running.
ƒUThe drain hose should not be placed higher than 85cm above the floor.
ö
Connecting the inlet hose
§ §
1.
Unscrew the fixing screw to attach
the faucet.
ö
Connecting the inlet hose (How to connect the hose of screw type.)
§ §
¥ To prevent leaks two rubber packings are supplied with the water inlet
hose inside the valve connector.
¥ If there is only one tap, connect the hose to the cold water inlet.
¥ Make sure the correct water valve is connected to the corresponding
tap.(IE : Hot inlet valve to hot water tap.)
¥ The connections are tightly fixed.
¥ When using only cold water, only cold inlet hose can be used.
1. Fix the red Marked inlet hose at the hot water tap and
at the inlet valve with the red filter on the rear side of
the machine.
2. Fix the other inlet hose at the cold water tap and at the
inlet with the white filter on the rear side of the machine.
The water supply pressure must be between 30 kPa and 1000 kPa
WARNING
6
2.
Push the connector up till the rubber
packing is in tight contact with the
faucet. Then tighten the 4 screws.
¥ Make sure that the rubber seal is
inside the hose connector.
3
Push the water supply hose vertically
upwards so that the rubber packing
within in the hose can adhere
completely to the faucet and then
tighten it by screwing it to the right.
¥ Your machine comes with only cold
water connection.
¥ Make sure that there are no kinks in
the hose and that it is not crushed.
Connector Rubber seal
Hot water tap
Cold
Hot
Cold
water
tap
Advertisement
Table of Contents
