ƒUKeep the transit bolts and spanner for future
use in case the machine is to be transported again.
ƒUIf the washer is not levelled, it may cause noise or
ƒUDo not use an extension cord or double adapter.
ƒUIf the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly
qualified person in order to avoid a hazard.
ƒUAlways unplug the machine and turn off the water supply after use.
ƒUConnect the machine to an earthed socket in accordance with current wiring regulations.
ƒUIf the appliance is supplied from a cord extension set or electrical portable outlet device, the cord
extension set or electrical portable outlet device should be positioned so it is not subject to
splashing or ingress of moisture.
ƒUIf a stationary appliance is provided with a supply cord and a plug, the instructions shall state that
the appliance must be positioned so that the plug is accessible.
ƒU To protect the washer during transportation, the special
4 bolts are locked. Before operating the washer, remove
( If they are not removed, it may cause heavy vibration, noise and
1. Locate the 4 bolts that secures the back cover.
2. Unscrew the 4 bolts with a spanner provided.
3. Take out the 4 bolts.
1. Select a place for installation
ƒUPlace it at a firm and even floor
ƒUPlace it more than 2cm away from the wall or other furniture
2.Check the gap
ƒUEnsure all feet are firmly on the floor.
The front is low
The rear is low
The left is low
The right is low
ƒUAfter adjusting the level, check it by shaking the washer.
Readjust the level if necessary.
ƒULevelling should be done within 1.5 degree angle.
How to disassemble the transit bolts.
ƒUTurn the front 2 levelling legs clockwise.
ƒUTurn the rear 2 levelling legs clockwise.
ƒUTurn the left levelling legs of the front and rear clockwise.
ƒUTurn the right levelling legs clockwise.