Sony BVM-X300 Operating Instructions Manual page 23

[SDI 4K/UHD Input Setting]
Submenu Setting
[Input Setting] Sets the input setting of the SDI 4K
signal.
[Input Setting1]

[Input Setting2]

[Input Setting3]

[Input Setting4]

[Input] Set the input connector of the SDI 4K
signal.
[Input1,2,3&4]: Select to use SDI IN

[Input1&2]: Select to use SDI IN 

[Input3&4]: Select to use SDI IN 

[Interface Format] Displays the interface format of the 4K
input.
[Quad-Link 3G/HD-SDI]

[Dual-Link 3G-SDI]

[Image Division] Set the image division of the 4K input.
[Auto]: Select for the Auto setting.

[2SI]: Select to receive images of the 2

[Square]: Select to receive images of

[Signal Format] Select from the following when
[Interface Format] is [Quad-Link 3G/
HD-SDI].
[Auto]

[422 YCbCr 10bit]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

[422 YCbCr 10bit] is set when
[Interface Format] is [Dual-Link 3G-
SDI].
, SDI IN , SDI IN , and
SDI IN  with Quad Link.
and SDI IN  with Dual Link.
and SDI IN  with Dual Link.
sample Interleave system.
the Square system.
Submenu Setting
[RGB Range] Select from the following when [Signal
Format] is set to RGB.
[Full]

[Limited]

[SDI Full Range]

[Color Space] Select the color space from the
following:
[ITU-R BT.709]

[EBU]

[SMPTE-C]

[Native]

[S-Gamut/S-Gamut3]

[S-Gamut3.Cine]

[DCI-P3]

[ITU-R BT.2020]

[EOTF] Select the gamma from the following:
[2.2]

[2.4]

[2.6]

[CRT]

[2.4(HDR)]

[S-Log3(HDR)]

[S-Log2(HDR)]

[SMPTE ST.2084(HDR)]

Note
The HDR display is a method to
faithfully display the brightness of
signals defined of 100% or more level
without compressing the brightness
parts.
In the HDR display, the cooling fan

is forcibly rotated regardless of
outside temperature.
In the HDR display, the screen saver

is forcibly set. [Off] cannot be
selected.
In the HDR display, [Flicker Free]

cannot be selected. [On] is always set
for signals of vertical frequency 24
Hz, 25 Hz, 48 Hz, and 50 Hz. [Off] is
always set for signals of 30 Hz and 60
Hz.
The protective function for the

OLED panel activates and inserts the
black level in one field according to
the input signal.
When the signal to display high
brightness images on the larger part
of the screen is input, blinking may
occur due to the protection function.
This is not a malfunction. There is
no effect on the throughout.
Using the unit with the high

brightness display for extended
periods may cause eyestrain or
reduction of eyesight. Be sure to take
an occasional break when using.
23
Adjustment Using the Menus