Sony BVM-X300 Operating Instructions Manual page 22

Submenu Setting
[Flicker Free] Set this to [On] to enable view images
without flicker.
An OLED panel can provide superior
video responsiveness and scan driving,
reproducing images with little contour
or afterimage. However, scan driving
can cause flicker when input signals
have a low vertical frequency (24P/PsF,
50i, etc.). Set [Flicker Free] to [On] to
greatly reduce this phenomenon.
With this mode set to on, quick-moving
images may exhibit contours or an
afterimage.
Note
In the HDR display, [Flicker Free]
cannot be selected. [On] is always set
for signals of vertical frequency 24 Hz,
25 Hz, 48 Hz, and 50Hz. [Off] is always
set for signals of 30 Hz and 60 Hz.
For details on the HDR (High Dynamic
Range) display, see page 23.
[Interlace] The interlace signal is displayed as the
interlace picture by inserting the black
line without I/P conversion processing.
A picture faithful to the original signal
with the same feel as a CRT is gained.


Note
The brightness of HDR display is
reduced by half when the interlace
display is selected.
Except for HDR display, the normal
brightness is set by increasing the value
of gain. However, the maximum
brightness is reduced by half.
22
Adjustment Using the Menus
[On]: Interlaced video is displayed.
[Off]: The progressive signals by I/P
conversion processing are
displayed.
Submenu Setting
[Screen Saver] Sets the screen saver function [On] or
[Off].
[On]: If a still image is displayed for

[Off]: The screen saver function is

Note
In the HDR display, this setting is
forcibly set to [On].
For details on the HDR (High Dynamic
Range) display, see page 23.
[Power On Setting] Sets this unit's setting status after the
unit is turned on. Select from [Last
Memory], [User Preset1], [User
Preset2], [User Preset3], [User Preset4]
or [User Preset5].
[User Reset] Returns to the factory default setting
except for the following:
Color temperature for [User1]

Color temperature for [User2]

Color temperature for [User3]

Color temperature for [User4]

Color temperature for [User5]

User Preset for [User Preset1]

Password setting

[Cancel]: Cancels reset.

[Confirm]: Resets the unit. When

[Input Setting]
more than 10 minutes, the
brightness of the screen is
automatically decreased to
reduce burn-in. The screen
returns to normal brightness
when you input a video signal to
the unit or operate the buttons
on the front panel of the unit.
While the screen saver is active,
the STATUS indicator flashes
every two seconds. Before the
screen saver starts up, the
STATUS indicator flashes every
second to notify users that the
screen saver will start up.
deactivated.
reset finishes, this unit restarts.