Messaging - Motorola Page Writer 2000X User Manual

After deleting messages, you must empty the Trashcan to free
the memory for use (see "To empty the Trashcan" on page 43).

Messaging

Why don't I receive messages?
Situations that will prevent you from receiving messages
include:
Your pager's radio mode may be set to Off. From the
Home screen, the status line will display "Storing
Messages". Reset your transmission mode to
Send/Receive or Receive Only. For information on
resetting you transmission mode, see "To set the
transmission mode" on page 20.
Your pager might be out of range of the nearest
transmitter. Check the icon in the lower right corner of the
Home screen. If you are out of range, your messages will
be transmitted when you are back within transmission
range.
Why does the Home screen status line read "Basic
Service" when the radio mode is set to
Send/Receive?
If you have just inserted a new battery or just disconnected the
pager from your PC, it can take a few minutes before you have
"Full Service" access. Your pager reregisters with the service
provider after any suspension in service. Also, if you are on
the perimeter of the transmission range, you might only have
message reception capabilities.
Why does the Home screen status line read
"Storing Messages"?
When your pager loses access to your service provider's
paging network, your messages are stored by the paging
network until your pager is ready to receive the messages.
Reasons why your pager might be unable to receive messages
include:
You have manually turned off transmission to your pager.
This occurs by setting the transmission mode to Off (see
"To set the transmission mode" on page 20), or by turning
off the pager (see "To turn off your pager" on page 18).
TM
78 PageWriter 2000X User's Manual