Maintenance; Dirt Cup - Hoover UH20020W Owner's Manual

Familiarize yourself with these home maintenance tasks as proper use and care
of your cleaner will ensure continued cleaning effectiveness.
The System Check Indicator located at (A), alerts you to possible system
performance issues. Please refer to the Troubleshooting section on page 12 for
possible causes and solutions.
Any other servicing should be done by an authorized service representative.
A thermal protector has been designed into your cleaner to protect it from overheating. When the thermal
protector activates the cleaner witll stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty dirt cup.
3. Inspect the nozzle/brushroll, filters, umbrella tube and hose for any obstructions. Clear obstructions
if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner needs
servicing.

DIRT CUP

WARNING
!
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
Do not operate cleaner without either the dirt
cup or filters in place.
Very fine materials, such as face powder or
cornstarch, may seal the filter and cause a
reduction in performance. When using the
vacuum for this type of dust, empty the cup
and clean the filters often.
How to Empty
3.2 Push dirt cup release button on top of dirt cup to
remove dirt cup.
3.3 Hold dirt cup over garbage can and press clean
release dirt cup button to empty. Make sure cup
bottom center opening is clear of debris. Snap
dirt cup bottom back into place after emptying.

3. MAINTENANCE

NOTICE
!
3.2
!
9
!
Actual model may vary from images shown.
3.1
A
3.3