Connection To Router - Motorola BR700 User Manual

INSTALLATION

Connection to Router

Reset
+12VDC Power LAN
When connecting your PC to the router, your PC must be installed
first with an Ethernet adapter.
You need two Ethernet cables for this procedure, one cable to connect the
router to the modem and one cable to connect a PC to the router.
1 A. If you have been running broadband to a single computer
before, unplug the Ethernet cable (that runs between your
modem and PC) from the back of your PC and plug it into the port
labeled WAN on the back of your router.
B. If you have not been running broadband to a single computer,
take one end of an Ethernet cable and plug it into the WAN port.
The WAN port is the only port that works for your connection from
the modem to the router.
2 Take the other end of the same cable and plug it into your cable
or DSL modem. You have now connected the router to the
modem.
3 To connect the PC to the router, use a different Ethernet cable
and plug it into your Ethernet port on your PC.
4 Use the other end of the same cable and plug it into one of the
LAN ports on your router. You have now connected your PC to
the router.
5 To connect more devices, repeat steps 4 and 5.
6 To configure the router, refer to Section 3: Configuration.
SECTION 2, INSTALLATION
4 3 2 1 WAN
SECTION 2
2-7