Electrical Connection To Router; Easy Software Setup; Manual Software Setup - Motorola BR700 User Manual

SECTION 2

Easy Software Setup

Manual Software Setup

2-6

Electrical Connection to Router

Your router does not have an On/Off power switch and therefore will
only be powered on by plugging in the power adapter:
1 Connect the power adapter to the router's Power port, found on
the back of the unit.
2 Then plug the power adapter into a grounded and surge
protected power outlet.
! The Power LED on the front panel lights green when
connected properly.
Run the Installation Wizard program from the supplied CD-ROM to
quickly setup your network. Once your network is up and running,
refer to Section 3:Configuration for advanced configuration.
If you'd prefer to manually setup your network, use this section to
configure it. This section details the physical connection of the router
to your network as well as the configuration needed by your PC.
To set up your network:
! Physically connect and power on the router
! Configure your PCs
If you don't want to use the Installation Wizard from the CD-ROM,
follow the instructions below. For advanced configurations, refer to
Section 3:Configuration.
SECTION 2, INSTALLATION
INSTALLATION
Reset
LAN
Power
To power
supply