Installation Instructions; Buit-In Installation Instructions; Preparing Cabinet Opening; Preparing Electrical Wiring - Amana CDU300DB Service Manual

Installation Instructions

Buit-In Installation Instructions

Preparing Cabinet Opening

Dishwasher is designed to fit into a minimum 34 1/2"
height and 24" width and depth. A minimum of 2" is
required between dishwasher and perpendicular
cabinet or wall. Dishwasher must not be installed more
than 10' from sink for proper drainage.
Note: Complete enclosure is not provided with
dishwasher. Installer must provide top, bottom,
back and side enclosures.

Preparing Electrical Wiring

WARNING
To avoid electrical shock which can cause severe
personal injury or death, open household circuit
breaker to dishwasher before installing or
servicing dishwasher. After installing or servicing
dishwasher, reconnect power.
Note: Electrical wiring must meet local codes and
ordinances. If wiring does not, contact a
licensed electrician.
1. Cut 1 1/2" maximum hole in cabinet for cable or
power cord. Wiring must enter within shaded area.
2. Connecting Dishwasher
Using Cable Direct Connection
Route cable as shown. Cable must extend a
minimum of 24" from back wall of cabinet.
Using Power Cord
Install a three-prong grounded receptacle
in rear of sink cabinet next to dishwasher.
Do not install receptacle in cabinet opening.
Receptacle must be installed at least 6" but not
more than 18" from cabinet opening.
Note:
Edges of cabinet opening for power cord must be
smooth and rounded. If cabinet is metal, edges of
opening must be covered with a rubber cord protector.
RS3300002 Rev. 0
Receptacle
5"
6
Alternate
Receptacle
5"
4"
4"
6"
Electrical Wiring
3"
August 1997