Start Operation - Panasonic MC-CJ919 Operating Instructions Manual

ENGLISH
Please read the safety instructions (P.3) before using this cleaner.
CAUTIONS
The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
●
DO NOT use hot air or hot surface to dry the fi lter. Dry it at room temperature for approximately 24 hours.
●
IMPORTANT: Before re-installing the washable fi lter, make sure it is completely dry to avoid damaging the appliance.
●
DO NOT use the telescopic wand when using the blower operation. Wand will get hot.
●
First, assemble the parts together.
(Hose,Telescopic wand,Floor nozzle)
Parts are set surely so as not to come off.
Connect the edge of the hose and the upper end of the
telescopic wand by inserting one into the other and
twisting together.
Attach the fl oor nozzle to the other end while aligning
the raised section with the hole.
(When removing them , push the tab down
while pulling on the telescopic wand.)
Alternative nozzles
Crevice nozzle:
For narrow gaps, etc.
Dusting brush:
For furniture,venetian
blinds, etc.
2
Adjust the nozzle
to suit the fl oor
Carpet
Cord rewind pedal
Press the
not the edge of the pedal.
Blower
How to use Blower
For locations where the nozzle will not enter,
connect the hose to the blower and blow the dust out.
Step 1
Turn off the appliance,
release the connection
pipe from hose inlet.
Connect the hose to
the blower.
Connection pipe
4
Telescopic wand
Length may be adjusted.
Parquet /
Bare fl oor
mark,
Step 2
Turn on the appliance and
blow the dust out.
Suction regulator
Use when strong suction causes
the nozzle to stick to the fl oor,
hindering movement.
Release pedal
Release pedal
Floor nozzle
(3D EZ Nozzle)
Step 3
Turn off the appliance,
connect the connection
pipe to the hose inlet.
After this, turn on the
appliance and clean the
dust.
Hose inlet
1

Start operation

Press
Press the mark, not
the edge of the pedal.
To increase or decrease the power,
slide the variable power control .
Hose
Variable Power
control
Dust cover
Cloth dust bag (in body)
Dust indicator
Turn the power control to the highest setting and
lift the nozzle off the fl oor.
If the dust indicator turns red, the cloth dust bag
is full and requires replacing the cloth dust bag.
How to use 3D EZ Nozzle
Remove the floor nozzle by pressing the
release pedal and you can use EZ Crevice or
EZ Upholstery easily anytime.
EZ Crevice
For narrow gaps, etc.
Changing the
cleaning power.
ON/OFF Switch
pedal
Plug
Power cord
EZ Upholstery
For sofa, etc.