Table of Contents
Advertisement
STEP 4 (See Diagram 4)
A.) Untie the Upper Sensor Wire (#41) from Handlebar Support and pull the Upper Sensor
Wire through the hole on the Computer Base (#32). Insert the two Pulse Sensor Wires
(#42) from the Handlebar (#19) through the small hole on the Handlebar Support. Pull the
two Wires out of the top opening and through the hole on the Computer Base.
B.) Attach the Handlebar (#19) to the Handlebar Support. Secure it with four M8 x 5/8" Chrome
Allen Bolts (#20), two Ø5/8" Chrome Flat Washers (#21) on the sides, and two Ø 5/8"
Chrome Bent Washers (#8) on the back.
8
DIAGRAM 4
Advertisement
Table of Contents
