Table of Contents
Advertisement
Operating the Computer
Count Up
The computer can be turned on by pressing any of the three keys or by simply pedaling the
bike. The values for Time, Dist, and Cal will start from Zero and accumulates upward.
Press Reset key to reset all values back to ZERO.
Count Down
By pre-setting a value in the computer, the function will count down from the preset value
back to Zero. When the value reaches Zero, the alarm will go off for 15 seconds.
For example, you want to work out for 5 minutes. Press the MODE key until TIME displayed
(not Scan Time). Press SET key until 5:00 shows up. You can repeat the same procedure
to enter Distance and Calorie.
Note:
Please note all values on this computer are approximate and they are for comparison
purpose only. Do not use these values for any medical or rehabilitation purpose.
Maintenance and Storage
1. Inspect and tighten all parts each time you use the machine. Replace any worn
parts immediately.
2. The bike can be cleaned using a damp cloth and mild non-abrasive detergent.
Do not use solvents.
3. Store the machine IN-DOOR. Excess moisture and water would cause rust on
the frame.
4. The machine shall be placed at least 24 inches away from the wall or/and any
other object such as furniture to provide safe access to and passage around
the machine.
5. To avoid possible injury, the help of two or more people are needed when
moving the machine around.
14
Advertisement
Table of Contents
