Table of Contents
Advertisement
STEP 2 (See Diagram 2)
A.) Attach the Handlebar Support (#3) to the Seat Support (#2). Connect the Middle
Sensor Wire (#12) from the bottom of Handlebar Support to the Lower Sensor Wire
(#13) from the main body of the bike. Connect the Upper Tension Connector (#10) to
the Bracket on the Lower Tension Connector (#11). See HOW TO CONNECT
TENSION CONNECTOR on next page. Adjust exercise tension by using the Tension
Adjustment Knob (#18) on the Handlebar Support.
B.) Secure the Handlebar Support to the Seat Support with two M8 x 5/8" Hex Bolts (#15)
and Ø 5/8" Black Bent Washers (#39) from the top. Then secure with two M8 x ½" Hex
Bolts (#14) and Ø 5/8" Black Flat Washers (#38) from the sides.
5
DIAGRAM 2
Advertisement
Table of Contents
