Troubleshooting - Bosch Vision 500 Series Operating, Care And Installation Instructions Manual

Troubleshooting

d WARNING
TO AVOID RISK OF
ELECTRICAL SHOCK!
Repairs or replacement of parts
shall be carried out by qualified
technicians or licensed
electricians only.
Problem
Dryer does not start. Dryer does not start.
Start/Pause" indicator light does not Start/Pause" indicator light does not
illuminate. illuminate. illuminate.
Cycle has been interrupted. A warning
signal is emitted and the display shows
CLn".
Cycle has been interrupted. A warning
signal is emitted and the display shows
E:12". E:12".
Degree of drying has not been reached
or the drying time is too long. or the drying time is too long.
Display may indicate E:03". Display may indicate E:03".
Drum light does not function. Drum light does not function.
30
Before calling Customer Service, check
whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
1. Set program selector to Off".
2. Turn off the circuit breaker.
3. Pull the main plug out of the
socket.
4. Call customer service
(see page 32).
Possible cause
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse or circuit breaker has tripped.
Start/Pause" button not pressed.
No program selected.
Door not closed.
Ambient temperature below 41°F (5 °C.)
Lint filter dirty.
Exhaust air duct is blocked or too long.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
Moisture sensor dirty.
Exhaust air duct is blocked or is too long.
Lint filter dirty.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
Degree of dryness not correctly set
No program selected.
Light bulb defective, light bulb burned out.
No power supply.
Light bulb is loose.
Troubleshooting items listed below may
not be covered by warranty service
Please rule out any of these issues
before calling for service.
Remedial action
Replace fuse or reset circuit breaker.
Press Start/Pause" button.
Select program.
Close door.
Increase room temperature.
Clean the lint filter as described on page 27.
Switch the dryer off/switch on again. If this does not
clear the error code, call Customer Service (pg. 32).
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 18.
Switch the dryer off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Clean moisture sensor as described on page 29.
Switch the dryer off/switch on again.
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 18.
Switch the dryer off/switch on again.
Clean filter as described on page 27.
Switch the dryer off/switch on again.
Spin laundry at higher speed in the washing
machine. Switch the dryer off/switch on again.
Select program with aid of the program selection
table (see page 22). Switch the dryer off/switch on
again.
Clean lint filter (see page 27).
Check exhaust air duct.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
800 Series, Change settings for degree of dryness,
see page 25
Select program.
Replace burned out bulb and reinstall the cover as
directed on page 29.
Check power supply.
Remove the bulb cover and if bulb is loose, tighten
bulb. Reinstall the cover as directed on page 29.