Accessories; Preparing To Transport The Dryer Step By Step - Bosch Vision 500 Series Operating, Care And Installation Instructions Manual

Accessories

The following optional accessories for
your dryer may be obtained from
customer service (see page 32) or from
your local dealer. Please follow the
installation instructions supplied by the
appropriate manufacturer.
Side exhaust kit
part no. WTZ 1265
Note:
See notes on maximum number of
elbows on page 18.
Bottom exhaust kit
part no. WTZ 1270
Note:
See notes on maximum number of
elbows on page 18.
i The bottom exhaust kit cannot be
used with a pedestal installed on
the dryer or if the dryer is stacked
with the washer.
Dryer rack
part no. WTZ1620
Use the dryer rack to dry washable
woolen textiles (e.g. sweaters) and
shoes.
Pedestal Mounting Kit
A storage pedestal with a pull-out
drawer is available as an accessory for
your dryer. The pedestal adds
approximately 15 inches to the height
of the dryer. See page 11 for
dimensions.
d WARNING
Appliance must not be mounted
on a pedestal in stacked
installations.
part no. WTZ 1610 is for a solid white
color pedestal.
Other color pedestals may be
available.
Reference part no. WTZ 1610"X" in
which the X designates an available
color (eg: A for Anthracite, S for silver).
Please inquire at your dealer for color
choices available.
You may also consult a current product
catalog or visit our website at:
www.boschappliances.com
If mounting the dryer on a pedestal,
follow the instructions supplied with the
pedestal.
Stacking Kits
There are two stacking kits available.
Basic Stacking Kit
This kit anchors the dryer on top of the
washer and adds approximately 0.63
inches (16 mm) to the stacked height.
See page 12 for dimensions.
part no. WTZ 1601 is for the basic
mechanical stacking kit.
Pull-Out Shelf Stacking Kit
This kit serves to stack the dryer on top
of the washer and also provides a pull-
out shelf. This kit adds approximately
1.52 inches (38.6 mm) to the stacked
washer/dryer height. See page 12 for
dimensions.
This kit may also be combined with the
pedestal mounting kit to provide a
pull-out shelf as well as a combined
increase in height of the dryer of
approximately 16.5 inches.
i
The pedestal can not be combined
with the pull-out shelf stacking kit
in stacked washer/dryer
installations.
part no. WTZ 1600 is for the solid
white pull-out shelf stacking kit.
Other color pull-out shelf stacking
kits may be available.
Reference part no. WTZ 1600"X" in
which the X designates an available
color (eg: A for Anthracite, S for silver).
Please inquire at your dealer for color
choices available.
Preparing to transport the
dryer step by step
i These procedures should only be
performed by a qualified person.
1. Rotate the program selector
to "OFF".
2. Disconnect the power supply (turn
the circuit breaker off, unplug the
appliance)
3. Turn off the water faucet
connected to the water supply
hose (Steam models only).
Disconnect the water supply hose.
4. Disconnect the exhaust duct from
the exhaust air outlet on the dryer.
5. Collect any accessories and
package them for shipment with
the appliance.
6. Close the door and secure with
adhesive tape.
7. Screw the height adjustable feet of
the dryer into the housing to
prevent them from being damaged
during transportation.
8. Reinstallation of the Dryer at the
New Location - refer to the
Installation Instructions in this
manual (see page 7).
19