Configuring Tcp/Ip - Motorola SB5102 User Manual

Introduction Before You Begin
SB5102 Cable Modem User Guide
Installation & Configuration

Configuring TCP/IP

The SB5102 cable modem contains all required software. You do not need to configure
the cable modem, but you must be sure that your computer is configured for
protocol for communication between computers). Perform one of:
•
"Configuring TCP/IP in Windows 98, Windows 98 SE, or Windows Me"
•
"Configuring TCP/IP in Windows 2000"
•
"Configuring TCP/IP in Windows XP"
•
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the
•
"Verifying the IP Address in Windows 98, Windows 98 SE, or Windows Me"
page 26
•
"Verifying the IP Address in Windows 2000 or Windows XP" on page 27
•
Follow the instructions in your Macintosh or UNIX user manual
Your cable service provider may provide additional instructions to set up your computer.
Troubleshooting FAQ
on page 15
on page 19
Glossary License
TCP/IP (a
on page 12
IP address:
on
11