Automatic Power Off - Fujitsu scansnap s1300i Basic Operation Manual

Automatic Power OFF

When the ScanSnap is turned on and left unused for the specified time (default is "4 hours"), it will
turn itself off automatically.
To turn the ScanSnap back on, perform one of the following operations:
l Press the [Scan] button on the ScanSnap (this will not start scanning)
l Close the ADF paper chute (cover) and open it again
HINT
l To continue using the ScanSnap, reset the time until auto power-off by performing one of the
following:
- Load a document in the ScanSnap
- Press the [Scan] button on the ScanSnap
- Close the ADF paper chute (cover) and open it again
l You can change the time of the ScanSnap to turn off automatically or change the setting so that it
will not turn off automatically. Set according to the following procedures:
1. Right-click the ScanSnap Manager icon
from the "Right-Click Menu" (page
a The [ScanSnap Manager - Preferences] window appears.
2. In the [Power] list, change the settings for [Power setting] based on how it is connected.
l A notification informs you 5 minutes before the ScanSnap turns off automatically.
in the notification area and select [Preferences]
39).
47
Turning the ScanSnap On or Off