Bewatec MediPaD 10 LX Operating Manual page 6

SAFETY
1.2 GENERAL SAFETY ADVICE
Observe the following safety advice when handling the device:
CAUTION – LIVE COMPONENTS
Danger of injury through electric shock, and risk of short‐circuit or fire!
– Do not open the device.
– Never expose the device to rain or humidity.
– Never use the device near plumbing units.
– Never connect the device to any power supply not specified by the manufacturer. Only replace
damaged cables with original cables.
– Do not insert any objects into the device through the slots or openings.
CAUTION – BREAKAGE OF GLASS
– The device is equipped with a glass front made of Corning® Gorilla® Glass.
– In case of breakage of the glass e.g. by dropping the unit or willful damage to property there is
the possibility for risk of cuts.
– Thoroughly clean the area where the device has been damaged.
– Send in the device for repair.
ATTENTION – DAMAGE TO THE DEVICE
– Protect the LCD device against heat.
– Do not position it directly next to radiators or heaters.
– Avoid positioning of the device in direct sunlight.
– Do not obstruct the ventilation slots of the LCD device.
– Repairs to the device may only be carried out by qualified personnel.
– During long periods of inactivity, disconnect the device from the power supply.
– Should foreign metallic objects or liquids enter the device, immediately disconnect the device from the
power supply. Before using the device again, have it checked by qualified personnel.
– After the transportation, allow the device to adjust to the surrounding temperature before starting
operation.
INFORMATION
If required, observe the project‐specific cabling diagrams or special characteristics when connecting
the device.
6 / 36 Operating manual MediPaD 10 LX