Pioneer Elite SC-89 Operating Instructions Manual page 189

Cautions on connecting the speaker cords
If the speaker cords get short-circuited, this unit's power may turn off and this
unit may be damaged. To prevent this, be sure to heed the cautions below.
When connecting the speakers, make sure that the exposed wire of
each speaker cord does not touch anything other than the correct
speaker terminal.
X
No Good!
Make sure the cords' exposed Make sure that exposed speaker Make sure that exposed
wires are not inserted too far wire does not extend outside the speaker wire does not
so that they extend beyond the speaker terminal and touch any touch the rear panel,
speaker terminals and touch other wire. screws, etc.
metal parts of the main unit (the
rear panel, screws, etc.).
QOK!
CD
Remove about 10 mm (3/8 in.)
of the plastic insulation and
twist together the exposed
speaker wire.
(g) Loosen the speaker terminal and
insert the speaker cord, making
sure that no exposed speaker
wire extends outside the terminal.
®
Tighten the speaker terminal to
secure the speaker cord.
Check that all the speaker cords are properly connected at both the
amplifier and the speaker ends.
Printed in Malaysia <ARM7161-A>