Www.desatech.com - Desa HDFB32C Safety Information And Installation Manual

INSTALLATION
Continued
INSTALLING FIREPLACE SCREEN
1. Insert each rod through nine rings located
at top of screen (see Figure 13).
2. Insert first rod into rear hole in left side
of firebox. Fasten rod to rear hole near
center of firebox using black shoulder
screw.
3. Insert other rod into front hole on right
side of firebox and fasten using remaining
shoulder screw.
Front and
Rear Hole
Rod
Ring
Screen
Figure 13 - Installing Fireplace Screen
FIREBOX INSTALLATION USING
OPTIONAL ACCESSORY MANTELS
This firebox may be installed using the cabinet
mantel and hearth base accessories against
a wall in your home. Follow the instructions
below to install the firebox in this manner.
Note: The instructions below show installation
using GMC11F/GMC1U/GMC13F series
cabinet mantels and the GC3333F/GC3334U/
GC3335F series hearth base accessories.
The hearth base accessory shown is optional
for this installation. You can install firebox and
cabinet mantel directly on the floor.
1. Assemble cabinet mantel, hearth base and
perimeter trim (Included with mantel). As-
sembly instructions are included with each
accessory.
. If using a blower, install a properly grounded,
10 volt three-prong electrical outlet at
firebox location if an outlet is not there. If
possible, locate outlet so cabinet mantel will
cover it when installed (see Figure 15).
113900-01D
3. Install gas piping to firebox location. This
service person must connect
firebox to gas supply. Follow all
local codes.
4. Place hearth base accessory against wall
Screw
5. Route flexible gas line through access
Hearth
Base
Cabinet
Mantel

www.desatech.com

installation includes an approved flexible
gas line (if allowed by local codes) and a
equipment shutoff valve. The flexible gas
line must be the last item installed on the
gas piping. See Connecting to Gas Supply
in your log set owner's manual.
WARNING: A qualified
at installation location. Cut an access hole
in hearth top to run flexible gas line to fire-
box (see Figure 14). Make sure to locate
access hole so cabinet mantel will cover
it when installed. Note: You can secure
base to floor using wood screws. Coun-
tersink screw heads and putty over.
hole in hearth base.
Rigid Pipe and Gas
Shutoff Valve
Figure 14 - Placing Hearth Base
Accessory Against Wall
Figure 15 - Installing Cabinet Mantel
Electrical
Outlet
Gas Line
Access
Hole
Electrical
Outlet
11