Table of Contents
Advertisement
INSTALLATION
Continued
6. Center cabinet mantel on hearth base
(see Figure 14, page 11). Make sure
mantel is flush against wall.
7. Break off nailing flanges (see Figure 16)
with hammer or pliers.
8. Place cardboard or other protective mate-
rial on top of hearth base. Carefully set
firebox on protective material, with back
of firebox inside mantel opening.
Figure 16 - Location of Nailing Flanges
Figure 17 - Inserting Firebox Into Cabinet
BUILT-IN FIREBOX INSTALLATION
Built-in installation of this firebox involves
installing firebox into a framed-in enclosure.
This makes the front of firebox flush with wall.
Optional perimeter trim is available (see Ac-
cessories, page 14) This perimeter trim will
extend past sides of firebox approximately
1/". This will cover rough edges of the wall
opening. If installing a mantel above the fire-
box, you must follow the clearances shown in
Figure 7, page 8. Follow the instructions below
to install the firebox in this manner.
1
Nailing
Flanges
Mantel
www.desatech.com
1. Frame in rough opening. Use dimensions
shown in Figure 18 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 19 for the rough opening.
The height is 33", which is the same as
the wall opening in Figure 18.
2. Install gas piping to firebox location. This
installation includes an approved flexible
gas line (if allowed by local codes) after
the equipment shutoff valve. The flexible
gas line must be the last item installed on
the gas piping. See Connecting to Gas
Supply in log set owner's manual.
3. Carefully set firebox in front of rough open-
ing with back of firebox inside wall opening.
IMPORTANT: If installing perimeter trim,
see instructions included with perimeter
trim accessory. You must install shoulder
screws now.
4. If using blower accessory, install and
properly ground a GA3555 three-prong
120 volt electrical outlet in firebox. Follow
instructions included with kit.
5. Attach flexible gas line to log set. See
Connecting to Gas Supply in log set
owner's manual.
6. Carefully insert firebox into rough
opening.
7. Attach firebox to wall studs using nails
or wood screws through holes in nailing
flange (see Figure 20, page 13).
33"
Figure 18 - Rough Opening for Installing
39
"
/
3
8
34
55
Figure 19 - Rough Opening for Installing
in Corner
17
/
"
3
4
34
3
/
"
4
in Wall
27
"
/
3
4
"
/
5
8
113900-01D
"
/
7
8
Hide quick links:
Advertisement
Table of Contents
