Inspecting Burners; For More Information, Visit Www.desatech.com For More Information, Visit Www.desatech.com - Desa P325 Owner's Operation And Installation Manual

OPERATING FIREPLACE
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: The receiver and hand-held remote control kit must be
purchased separately (see Accessories , page 29). Follow installa-
tion instructions on pages 10 and 11 of this manual.
1. After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position. Slide the selector switch
to the REMOTE position. Note: The burner may light if
hand-held remote ON button was on when selector switch
was last turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch in the REMOTE
position when the pilot is not lit. This will drain the battery.
IMPORTANT: Be sure to press the ON/OFF buttons on the
hand-held remote control unit for up to 3 seconds to assure
proper operation.
2. Press the ON/OFF button to turn the burner on and off.
When turning burner off, the pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the con-
trol knob on the heater to the OFF position.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Press in and turn control knob clockwise
position.
Shutting Off Burner Only (pilot stays lit)
Turn remote control/wall switch (if installed) to the OFF position.

INSPECTING BURNERS

Check pilot flame pattern and burner flame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper flame height.
Alterations may have occurred during shipping and handling. The
pilot is located on the back right hand side of the burner.
The height of the thermopile must be 3/8" to 1/2" above the pilot flame.
The flame from the pilot burner must extend beyond the thermopile.
If your pilot assembly does not meet these requirements:
• Turn the adjustment screw marked pilot clockwise to decrease
or counterclockwise to increase the flame to proper size (see
Figure 36, page 16). Do not remove the adjustment screw.
• see Troubleshooting, pages 19 through 21
108660-01D
to the OFF
Clockwise
For more information, visit www.desatech.com
For more information, visit www.desatech.com
OPERATING FIREPLACE
Optional Hand-Held Remote Operation
To Turn Off Gas to Appliance
INSPECTING BURNERS
Ignitor
Figure 38 - Correct Pilot Flame Pattern
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flames should
go up through the middle of logset. Flames should not "spill" to the
edges of the pan or sides of the logset.
Figure 39 shows a typical flame pattern. If burner flame pattern differs
from that described:
• turn appliance off (see To Turn Off Gas to Appliance)
• see Troubleshooting, pages 19 through 21
P324 and VP324 Models
P325(B) and VP325(B) Models
Figure 39 - Typical Flame Pattern
Pilot Assembly
Burner Flame Pattern
Thermopile
Pilot Burner
17
17