Mitsubishi Electric GB-50ADA-A Installation Instructions Manual page 29

11-2-2. Power consumption data
The format of the CSV file that is output when the power consumption data is saved is as follows:
Note: Dates in the folder name, the file name,and the file contents are displayed in the format selected on the Initial
Setting Web.
"March 10, 2010" would be expressed
as [10/03/2010] in the [dd/mm/yyyy] format,
as [03/10/2010] in the [mm/dd/yyyy] format, and
as [2010/03/10] in the [yyyy/mm/dd] format.
[File name]
ChargeParameter_[date]MCPA[ PI controller (PAC-YG60MCA) address (fixed 2 digits)]-[Time zone (1-5)].csv
Example) ChargeParameter_10-03-2010MCPA50-3.csv
[File contents]
The format of each CSV file is as follows. Each file contains up to 62 days of data.
* Delimiter ("," or ";") and decimal point ("." or ",") that are used by the CSV file are selected on the Initial Setting Web.
1st line
2nd line
3rd line
4th line
5th to 66th line (max.)
*No. is consisted of three-digit number: address (two digits) and Time zone (one digit).
*Power consumption data range is 0.00 through 999999.99. If the count value exceeds the maximum value, the count
value goes back to 0.00.
*The file is not output until the operation starts because the data does not exist.
*When the Energy Management License Pack has not been registered, the file is not output.
Example)
202
10/03/2010-12/03/2010
MCP 50-3
No., Date,Count value(Ch1), Count value(Ch2), Count value(Ch3) , Count value(Ch4)
503,10/03/2010,100000,0,0,0
503,11/03/2010,100100,0,0,0
503,12/03/2010,100250,0,0,0
Item
File class
Data range
Target trend
Item
Data
Power consumption: 202
Records the range of data read in from non-volatile memory
Start date + "-" + End date
"MCP"+[ PI controller address]-[Time zone]
"No., Date, Count value(Ch1), Count value(Ch2), Count value(Ch3) ,
Count value(Ch4)"
no., date, count value(Ch1), count value(Ch2), count value(Ch3) ,
count value(Ch4)
* The value for each data type is a cumulative value since the
beginning of operation.
- 29 -
Format