Cooking Guide; Delayed Cooking - GE JES922T Use And Care & Cooking Manual

The Minute/Second Timer
The Minute/Second Timer has three timing
functions:
It operates as a minute timer.
It can be set to delay cooking.
It can be used as a hold setting after defrosting.
The Minute/Second Timer operates without
microwave energy.
How to Time a 3-Minute Phone Call
Step 1: Touch MIN/SEC TIMER pad.
Step 2: Touch number pads 3,0 and O (for 3 minutes
and no seconds).
Step 3: Touch START. Display shows time counting
down. The timer signals when time is up.
Time Cook
Time Cook allows you to microwave for a preset
amount of time.
Power level 10 (High) is recommended for most
cooking, but you may program up to 3 cooking stages,
varying the power level for each stage if desired. See
the Cooking Guide.
To become better acquainted with time cooking, make
a cup of coffee by following the steps below.
Step 1: Fill a
2/3 full of
water, add
1 teaspoon of
instant coffee
and stir to
dissolve. Use a
cup that has no
metal decoration
and is microwave-safe (refer to Microwaving Tips
section). Place cup in oven and close door.
I I
TIME COOK
The Minute/Second Timer can also be used to
program a "holding time" between microwave
cooking functions. The time can range from one
second to 99 minutes and 99 seconds. A holding or
standing time may be found in some of your own
recipes or in the Cooking Guide.
Programming Delayed Cooking
To delay cooking up to 99 minutes and 99 seconds,
touch TIME COOK and enter cook time. Touch
delay cooking. Touch START. Timer will count down
to zero and cooking will begin.
Step 3: Select your time. Touch pads 1,0
and O for one minute.
Because automatic power level 10 is recommended
for this cup of coffee, there is no need to change the
power level. (If power level 10 is not appropriate, see
"How to Change Power Level" below.)
Step 4: Touch START.
Step 5: When time is up, the oven signals and flashes
"End." The oven, light and fan shut off.
Step 6: Open the door.
How to Change Power Level
After setting cooking time, touch POWER
LEVEL pad, then touch desired number for new
power level.
9