REDCAT RockSlide S10 XT Owner's Manual page 8

5. ESC And Receiver Placement
The RS10XT is a fully assembled RTR vehicle. The following is intended to familiarize you with the placement of
electrical components.
Electronic Speed Controller (ESC)
The ESC is attached to the radio
tray with foam mounting tape.
Receiver
The 2.4GHz receiver is attached to
the radio tray with foam mounting
tape.
Slide the receiver antenna through
the antenna mount (see the photo).
Install the antenna tube (found in the
package.) over the antenna and insert
into the antenna mount.
Splash-proof Receiver
7
If you remove the ESC, clean off the
old tape residue and use a new piece
of foam mounting tape to re-install.
If you remove the receiver, clean off the old
tape residue and use a new piece of foam
mounting tape to re-install.
The motor connectors (front/rear motor) are secured to
the chassis with plastic ties. Be sure the yellow motor wire
is connected to the yellow ESC wire and blue to blue.
The new splash-proof 2.4Ghz receiver is provided with an extra
binding plug.
The binding plug (to Channel 4)
The power switch is secured with
two self tapping screws.
(2*6mm)- Screw No.: S093