Epa Emission Control Statement/Warranty Coverage (U.s. Only) - Arctic Cat 500 Operato's Manual

U.S. EPA Emission Control Statement/Warranty
Coverage (U.S. Only)
STATEMENT/WARRANTY
Arctic Cat warrants to the original retail purchaser, and each subsequent purchaser, that all U.S. EPA-
certified Arctic Cat ATV's are designed, built, and equipped to conform to all U.S. EPA Emission Control
Regulations. Please read the following information completely.
Your authorized Arctic Cat ATV dealer will repair or replace any defective emission-related component
at no cost to you during the warranty period. You may have non-warranty service performed by any
repair establishment that uses equivalent components. The regulations provide significant civil
penalties for tampering that causes your ATV to no longer meet U.S. EPA emission standards.
Arctic Cat further warrants that the engine and its emission-related components are free from defects in
materials or workmanship that could cause the engine to fail to comply with applicable regulations
during the warranty period.
If you have any questions about this information, or the emission warranty coverage statement, contact
your local authorized Arctic Cat ATV dealer.
WARRANTY PERIOD
The emission warranty period for this ATV begins on the same date as the standard warranty coverage
and continues for 30 months or 3100 miles, whichever comes first.
COMPONENTS COVERED
The emissions warranty covers major emissions control components and emission-related components
listed as follows:
Engine Management and Sensors
Barometric Pressure Sensor
Camshaft Position Sensor
Engine Control Module (ECM)
Engine Coolant Temperature Sensor
Intake Air Temperature Sensor
Manifold Absolute Pressure Sensor
Oxygen Sensor
Throttle Position Sensor
Crankshaft Position Sensor
Exhaust Temperature Sensor
Ignition System
Ignition Coil
Knock Sensor System
Spark Plugs
Capacitive Discharge Ignition (CDI) Module
Magneto Pick-Up
OWNER'S RESPONSIBILITIES
The owner of any ATV warranted under this Arctic Cat Emission Control Statement is responsible for
the proper maintenance and use of the ATV as stated in the Operator's Manual. Proper maintenance
generally includes replacement and service, at the owner's choosing, such items as air filter, oil and oil
filter, or any other part, item, or device related to emissions control as specified in the Operator's
Manual. It is the owner's responsibility to ensure that the ATV is used in a manner for which it was
designed.
Fuel/Air System
Fuel Injectors
Fuel Pressure Regulator
Fuel Pump
Carburetor(s)
Turbocharger Assembly
Air Bypass Valve
Turbo Waste Gate Control Valve
Crankcase Ventilation System
ISC Valve
Miscellaneous Items Used in
Aforementioned Systems
Connectors
Switches
Grommets
Clamps
Hoses
Ties
Gaskets
Wiring
7