Chapter 1: Introduction; Professional Shop Manual Intent; Fasteners - Cub Cadet RZT-S Zero Shop Manual

Professional Shop Manual intent

This Manual is intended to provide service dealers with an introduction to the mechanical aspects of the RZT-S
Zero zero-turn mower.
Disclaimer: The information contained in this manual is correct at the time of writing. Both the product and the infor-
mation about the product are subject to change without notice.
About the text format:
NOTE: is used to point out information that is relevant to the procedure, but does not fit as a step in the proce-
dure.
• Bullet points: indicate sub-steps or points.
Caution is used to point out potential danger to the technician, operator, bystanders, or sur-
! CAUTION ! CAUTION
rounding property.
Warning indicates a potentially hazardous situation that, if not avoided, could result in death
! WARNING ! WARNING
or serious injury.
Danger indicates an imminently hazardous situation that, if not avoided, will result in death or
! DANGER ! DANGER
serious injury. This signal word is to be limited to the most extreme situations.
Disclaimer: This manual is intended for use by trained, professional technicians.
• Common sense in operation and safety is assumed.
• In no event shall MTD or Cub Cadet be liable for poor text interpretation or poor execution of the proce-
dures described in the text.
• If the person using this manual is uncomfortable with any procedures they encounter, they should seek
the help of a qualified technician or Cub Cadet Technical Support.

Fasteners

• All of the fasteners used on these mowers are sized in fractional inches.
• If a fastener has a locking feature that has worn, replace the fastener or apply a small amount of releas-
able thread locking compound such as Loctite® 242 (blue).
• Some fasteners like cotter pins are single-use items that are not to be reused. Other fasteners such as
lock washers, retaining rings, and internal cotter pins (hairpin clips) may be reused if they do not show
signs of wear or damage. This manual leaves that decision to the judgment of the technician.

CHAPTER 1: INTRODUCTION

Introduction
1