Kyocera FS-4100DN Operation Manual page 110

Print Quality (Setting print quality)
In Print Quality menus, you can set the KIR mode, EcoPrint mode, and other settings.
The options available in Print Quality are as follows:
• KIR (Selecting the KIR mode)...4-48
• EcoPrint (Selecting the EcoPrint mode)...4-48
• Print Resolution (Selecting the Print Resolution)...4-49
• Print Density (Selecting the Print Density)...4-49
Print Quality:
********************- 1 KIR
2
EcoPrint
3 Print Resolution
KIR (Selecting the KIR mode)
This printer incorporates the KIR (Kyocera Image Refinement) smoothing function. KIR uses the software to enhance
resolution, resulting in high quality printing at resolution of 600 dpi and 300 dpi. The default is On. KIR has no effect on the
printing speed.
KIR:
1 Off
2 *On ********************-
EcoPrint (Selecting the EcoPrint mode)
By enabling EcoPrint mode, you can minimize the amount of toner used during printing. Because images printed in this
mode may be slightly coarser than those printed in standard resolution, you should use EcoPrint for test prints or other
situations where high-quality prints are not required. EcoPrint has no effect on the printing speed.
Use the procedure below to select EcoPrint mode. The default setting is Off.
EcoPrint:
1 *Off
********************-
2 On
3
4
1
2
a b
[ Exit ]
1
2
a b
3
4
1
2
a b
Press or to select the desired character code set.
Press [OK]. The character code set is set and the Print Settings
menu reappears.
In the Print Settings menu, press
Quality.
Press [OK]. The Print Quality menu screen appears.
In the Print Quality menu, press
Press [OK]. The KIR screen appears.
Press or to select whether the KIR mode is enabled.
Press [OK]. The KIR mode is set and the Print Quality menu
screen reappears.
In the Print Quality menu, press
Press [OK]. The EcoPrint screen appears.
4-48
Operation Panel
or to select Print
or to select KIR.
or to select EcoPrint.