Motorola MVME5100 Series Specification Sheet page 4

PCI Expansion Connector
Address/Data: A32/D32/D64
PCI Bus Clock: 33 MHz
Signaling: 5V
Connector:
114-pin connector located on the planar
of the MVME5100
Power Requirements
(not including power required by PMC or IMPC modules)
+5V 5%
MVME5100: 3.0 A typ.
MVME5100 with
3.2 A typ.,
MVME761:
4.0 A max.
Board Size
Height: 233.4 mm (9.2 in.)
Depth: 160.0 mm (6.3 in.)
Front Panel Height: 261.8 mm (10.3 in.)
Width: 19.8 mm (0.8 in.)
Max. Component 14.8 mm (0.58 in.)
Height:
I P M C M o d u l e s
IPMC Modules
PMC Interface
Address/Data: A32/D32/D64, PMC PN1, PN2, PN3,
PN4 connectors
PCI Bus Clock: 33 MHz
Signaling: 5V
Basic, single-wide; P2 I/O
Module Type:
SCSI Bus
Controller: Symbios 53C895A
PCI Local Bus DMA: Yes, with PCI local bus burst
Asynchronous (8-bit 5.0MB/s
mode):
20.0MB/s (8-bit mode), 40.0MB/s (16-bit
Ultra SCSI:
mode)
Note: 16-bit SCSI operation precludes the use of some PMC Slot 2
signals.
Synchronous Serial Ports
Controller: 85230/8536
Number of Ports: Two (IPMC761); one (IPMC712)
IPMC761: TTL to P2 (both ports), SIM
Configuration:
configurable on MVME761;
IPMC712: EIA-232 to P2
Baud Rate, bps max.: 2.5M sync, 38.4K async
Oscillator Clock Rate 10 MHz/5 MHz
(PCLK):
Asynchronous Serial Ports
Controller: 16C550 UART; 85230/8536
Two (IPMC761); three (IPMC712)
Number of Ports:
Configuration: EIA-574 DTE (IPMC761);
EIA-232 (IPMC712)
38.4K EIA-232, 115Kbps raw
Async Baud Rate, bps
max.:
+12V 10% –12V 10%
8.0 mA typ. 2.0 mA typ.
0.2 A typ. 0.1 A typ.
0.5 A max. 0.3 A max.
Parallel Port
Controller: PC97307
Configuration: 8-bit bi-directional, full IEEE 1284 sup-
port; Centronics compatible (minus EPP
and ECP on MVME712M)
Modes: Master only
Power Requirements
(additional power load placed on MVME5100 with IPMC installed)
IPMC761
+5V: 0.5 A max.
+3.3V 0.75 A max.
T r a n s i t i o n M o d u l e s
Transition Modules
I/O Connectors
MVME761
Asynchronous Two, DB-9 labeled as
Serial Ports:
COM1 and COM2
Synchronous Two HD-26 labeled as
Serial Ports:
Serial 3 and Serial 4
(user configurable via
installation of SIMs),
Two 60-pin connectors
on MVME761 planar
for installation of two
SIMs
Parallel Port: HD-36, Centronics
compatible
10BaseT or
Ethernet:
100BaseTX, RJ-45
SCSI: 8- or 16-bit, 50- or 68-
pin connector via P2
adapter
Board Size
Height: 233.4 mm (9.2 in.)
Depth: 80.0 mm (3.1 in.)
Front Panel Height: 261.8 mm (10.3 in.)
Front Panel Width: MVME761: 19.8 mm (0.8 in.)
MVME712M: 39.6 mm (1.6 in.)
All Modules
Environmental
(Minimum of 400 LFM (linear feet per minute) of forced air cooling is
recommended for operation in the higher temperature ranges.)
Operating
0° C to +55° C
Temperature:
(inlet air temp. w/forced
air cooling)
Humidity (NC): 5% to 90%
Vibration: 2 Gs RMS,
20–2000 Hz random
IPMC712
0.5 A max.
0.75 A max.
MVME712M
Three, DB-25 labeled
as Serial 1, Serial 2,
and Serial 3
One, DB-25 labeled as
Serial 4
D-36, Centronics com-
patible
not available
8-bit, standard SCSI D-
50
A l l M o d u l e s
Nonoperating
–40° C to +85° C
5% to 90%
6 Gs RMS,
20–2000 Hz random