Fakir 9800 S Oko Power Instructions For Use Manual page 16

GB
Cleaning Tiled Floors
Cleaning Upholstery
16
OPERATING
C- Place the carpet spray extraction nozzle on the floor, pull
the lever of the metering valve and move the nozzle blowly
to the rear across the carpet at the same time. In this way
the cleaning solution is sprayed under pressure onto the
dirty area and is immediately sucked up again together with
the dirt. To move the nozzle in a forward direction, release
the valve lever and lift the nozzle clear of the carpet. The
entire area is covered by cleaning adjacent strips.
NOTICE!
If, temporarily no spray extraction liquid is
needed; switch off the pump.
D- Float Valve - When the liquid in the tank reaches the ma-
ximum level, the float valve will automatically close the in-
take aperture in the hood, interrupting the intake process.
Switch the appliance off immediately and withdraw the
mains plug. Now carry or pull the complete appliance to the
disposal point, remove the connection hose from the
spray extraction liquid tank and the pressure hose from
the hood, then empty the canister.
E- Tiled floor cleaning attachement for
carpet spray extraction nozzle. Push the
attachement onto the carpet spray
extraction nozzle, then proceed as
described under "spray extraction of
carpeted floors" above.
F- The tiled floor cleaning attachement
can simply be pulled off when no longer
required.
G- The upholstery cleaning nozzle is
supplied for the purpose of cleaning
upholstery, car seats etc. To seperate the
connection, turn the bayonet fitting in
the opposite direction and pull off.