Changing Flow Restrictor Changing Flow Restrictor - Flowmatic FMRO5-M-MT Installation, Operation And Maintenance Manual

Step 3 Pull fi rmly on the membrane to remove from the housing and
discard.
Unwrap new membrane and lubricate the o-rings with water
Step 4
soluble lubrication such as KY Jelly ® before inserting into
housing. Insert end with the two black O-rings into the cap.
Twist the membrane as you push fi rmly into the cap.
Step 5 Replace the vessel onto the cap by turning clockwise. Tighten
securely.
Changing the Flow Restrictor
Step 6 The fl ow restrictor plug (part no. 164015) must be replaced each
time you change the Membrane (part no.110015.) Remove the
existing fl ow restrictor with a screwdriver and discard.
Step 7 Insert the new fl ow restrictor plug and tighten.
Step 8 Follow the Start Up Instructions on page 11.
Page 15