3/8" Black Tube Connection; How To Use Quick Connect Fittings - Flowmatic FMRO5-M-MT Installation, Operation And Maintenance Manual

3/8" Black Tube Connection from faucet
Note: The tubing must be as SHORT and STRAIGHT as possible to the drain saddle, making a
downward slope from module to drain saddle to allow for proper drainage.
Step 25 Measure the black tube from faucet to the black drain
saddle and make a straight cut through tube.
Step 26 Remove black plastic nut from drain saddle. Slip black tube
through black nut. Insert black tube into the opening in the
drain saddle and hand tighten the black nut, and add 1/4 turn
with a wrench.
This is a gravity fed line, if there is any bend or dip in the
Note:
tube the rinse water will not fl ow into the drain properly.
Water will back up and come out the air gap hole in the
back of the faucet base.
How to use the quick connect fi ttings on the RO Module
To make a connection, the tube is simply pushed into the fi tting. Place a piece of tape 1/2" from end
of tube to indicate how far the tube should be inserted. The unique patented John
system holds the tube fi rmly in place without deforming it or restricting fl ow.
Cut the tube square. It is essential that the outside
diameter be free of score marks and that burrs and sharp
edges be removed before inserting into fi tting.
Push the tube into the fi tting, to the tube stop. The
collet (gripper) has stainless steel teeth which hold
the tube fi rmly in position while the O-ring provides a
permanent leak proof seal.
Fitting grips before it seals. Ensure tube is pushed into
the tube stop.
Pull on the tube to check that it is secure. It is a good prac-
tice to test the system prior to leaving site and /or before
use.
To disconnect, ensure the system is depressurized be-
fore removing the tube. Push in collect squarely against
face of fi tting. With the collect held in this position, the
tube can be removed. The fi tting can then be reused.
Page 10
Guest® ® ® locking locking