Table of Contents
Advertisement
I/O Panel
Item
Label
1
HDBaseT/LAN*
2
COMPUTER-1
3
3D SYNC OUT
4
MONITOR-OUT
5
DVI-D
6
HDMI
7
DisplayPort
8
COMPUTER-2
9
CONTROL
10
TRIGGER
11
Power Switch
12
13
Power Socket
14
REMOTE
Note:
If your video equipment has various input sources, it is recommended to connect in priority of HDMI/
DVI-D, component (through VGA), Composite for better picture quality.
* Notes on HDBaseT
■
Use a shielded cable rated at CAT5e or better.
■
Maximum transmission distance is 100 m.
■
However, maximum transmission distance may be shorter in some environments.
■
Do not use the LAN cable when it is coiled or bundled.
■
Inserting or removing the LAN cable during projection may cause noise.
■
Connectivity with all HDBaseT transmitters on the market is not guaranteed.
■
Some HDBaseT transmitters may not enable correct projection when used to connect source
equipment to the projector.
1
2
3
4
9
10
11
12
Connect to the RJ45 cable.
Connect to RGB, HD component or PC.
Connect to the 3D IR synchronization signal transmitter.
Connect to other display equipment for an additional display option.
Connect to DVI-D devices.
Connect to HDMI devices.
Connect to devices that contain a DisplayPort device.
Connect BNC-type input connectors to the RGB or YPbPr/YCbCr
output signal video equipment.
Connect to the PC for system maintenance and projector
maintenance.
Provide 12V (+/- 1.5) output for screen operation.
Turn on or off AC power of the projector.
Connect to an PC for maintenance.
Connect the projector to a wall socket for power.
Connect a 1.5 mm jack from a wired remote.
15
5
6
7
8
13
14
Description
Advertisement
Table of Contents
