Table of Contents
Advertisement
The default setting for a new note is octave 5.
Note Entry Sequence
1 Enter a sharp (
2 Press a keypad key to select the note. (required)
3 Set the length after selecting the note. If you do
4 Set the octave after selecting the note. If you do
You can perform the following tasks when creating a tone:
Task
insert a rest
132
Octave Setting
5
6
7
Action
necessary. (optional)
not specify a length, the default length (4) is
used.
not specify an octave, the default octave (5) is
used.
Octave
increase 1 octave
increase 2 octaves
#
) before selecting the note, if
Action
Enter 1 or more rests
( 40 characters) as needed in the
tone sequence. Set the length of
the rest ( 1 to 8 ) after you enter the
rest, just as you would for a note.
base
Advertisement
Table of Contents
