Installation Instructions - Sharp R-899P User Manual

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity , (do not remove the waveguide cover), and the
feature sticker from the outside of the door, if there is one. Check the unit for any damage, such as a
misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door.
If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable
6) 2 Cookbooks
3. Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven
should be placed at least 80 cm or more above fl oor. You should also keep children away from the door
to prevent them burning themselves.
4. Place the turntable over the turntable motor shaft on the oven fl oor. Refer to OVEN DIAGRAM on page
E-4. NEVER operate the oven without the turntable.
5. This oven is designed to be used on a countertop only. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow space of at least 40 cm from top of the oven for air ventilation.
This oven is not designed to be built-in to a wall or cabinet.
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage and frequency must correspond to the one indicated on the rating label on the back
of the oven.
7. This appliance must be earthed:
The wires in power supply cord are coloured in accordance with the following code:
As the colours of the wires in the power supply cord of this appliance may not correspond with the
coloured marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
The wire which is coloured blue must be connected to the terminal which is marked with the letter N
or coloured blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L
or coloured brown.
* In order to prevent possible electric shock, please install the grounding wire to the earth wire connecting
screw at the rear of the water oven in case of no 3 holes socket available in your residence.
R-899P [EN].indd Sec1:3 R-899P [EN].indd Sec1:3
2) Turntable support
IMPORTANT
Green-and-yellow
Blue
Brown
3) Low rack 4) High rack
: Earth
: Neutral
: Live
or coloured green or green-and-yellow.
E – 3
5) Operation manual
8/13/09 2:36:37 PM 8/13/09 2:36:37 PM