Jenn-Air Jds8850cdb Installation Instructions Manual page 14

To Convert Gas Pressure Regulator
1. Locate gas pressure regulator at the back of the range.
IMPORTANT: Do not remove the gas pressure regulator.
2. Unscrew the regulator cap and remove the plastic cover.
A. Plastic cover
B. Regulator cap
3. Flip the regulator cap over and replace the plastic cover.
A
A. Natural gas position
B. LP gas position
C. Plastic cover
4. Screw the regulator cap securely back into place. Do not
overtighten.
14
2
A
B
B
C
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
A
B
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
4. Apply masking tape to the end of a ⁹⁄₃₂" (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set Natural gas orifice spud aside.
A
A. Natural gas orifice spud
B. Dual burner
C. Single burner
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the lower left side of
the front frame for proper sizing of LP gas orifice spuds for each
burner location.
LP Gas Orifice Spud Chart for Model JDS8850
Location Burner Rating
Right Front 14,000 BTU
Right Rear 4,000 BTU
Left Front 13,000 BTU
Left Rear 9,100 BTU
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart." On dual
burners (on some models), replace the center and outer
spuds.
C
D
B C
Color Number
Red 114L
Blue 64L
Center: White Center: 55L
Outer: Orange Outer: 97L
Clear 91L