Starting Up For The First Time; Starting Up For The Fi Rst Time; Starting Up Your Pc - Medion P5110 D User Manual

AUS

Starting up for the first time

Starting up for the first time
The operating system and all hardware drivers are pre-installed. You do not
need to install any of the discs supplied.
For some programs (e.g. telephone CDs or encyclopaedias), it may be
necessary to insert the relevant disc to call up the data stored on it. The
software will prompt you to do this if necessary.
Once you have made all of the connections and screwed on all of the required
connections, you can start up your PC:

Starting up your PC

− Switching on the monitor.
− Switch on the mains switch
switch to 0 to disconnect the power supply.)
− Press the On/Off switch
Your PC will now start and run through various steps.
There should be no bootable disk (e.g. the recovery disc) in
the optical drive as this will prevent the operating system
from being loaded from the hard drive.
The operating system will be loaded from the hard disk drive. The loading
process takes a little longer during the initial setup. Once all the necessary
data has been entered, the operating system will be set up. The operating
system is fully loaded once the Windows® start-up screen appears.
NOTICE!
Data loss!
The initial installation may take a few minutes. Do not disconnect the
PC from the power supply during initial installation and do not switch
it off. This may adversely affect the installation. Only switch off the
PC when installation has been successfully completed and the start
screen appears.
− Follow the instructions on the screen. Step-by-step instructions will guide
you through the process to be followed.
24
www.medion.com.au
by moving it to the setting I. (Set this
5
once to switch on your PC.
1
AFTER SALES SUPPORT
1300 884 987
AUS