Programming Phone Number/Access Code/De-Access Code; Factory Reset - Motorola GP2000 Service Manual

4-22
6. Press PTT or MON, when the complete ID has been entered.
7. Turn off your radio, if you have completed the programming, or proceed to the next parame-
ter.
4.10.5 Programming an Phone Number/Access Code/De-access Code
Scenario: To program the phone number, 9-72886338 (where Ò-Ó represents a Pause digit), at
memory location 8.
Steps:
1. Enter Programming Mode, by pressing MON and turning on the radio.
2. Press + or - until RW is displayed.
3. Press PTT or MON until TELNO-8 is displayed.
4. Press +. The cursor will be placed on the Þrst character.
5. Use the keypad to enter 9.
6. Enter a Pause digit, by entering * followed by #. These two characters will be converted into a
Pause, represented by Ô-Õ.
NOTE: Each Pause digit entered shortens the overall length of the code/number by a digit.
7. Use the keypad to enter the rest of the phone number.
NOTE: If a mistake is made, use + or - to move to the appropriate location and then re-enter the
correct character. To erase the complete phone number/code, enter # 16 times.
8. Press PTT or MON, when the complete phone number has been entered.
9. Turn off your radio, if you have completed the programming, or proceed to the next parame-
ter.
4.11

Factory Reset

This feature allows you to erase certain programmable parameters and restore the radio to the
factory default settings. The radio, upon reset, clears all memory channels, phone numbers, and
restores the default settings of RW parameters.
1. Set the radio in Dealer ConÞguration (if it is operating in User ConÞguration).
2. Press and hold Ð and MON together, while turning on the radio. LCD displays INIT OK.
3. Press PTT to conÞrm factory reset, or turn off the radio to exit.
NOTE: When factory reset is in progress, LCD displays INITIAL for one second. When factory
reset is completed, radio turns itself off, and back on again. The radio is now restored to its
default factory settings.
Programming Mode