Valve Lash - MTD 61 series Shop Manual

Valve lash

Valve lash is the clearance between the top of the valve stem and the rocker arm. The valve lash should be
checked after the first 25 hours of use and every 100 hours after that. Valve lash can be checked and adjusted using
the following steps:.
Spark plug
Muffler
High tension lead
Figure 1.12
Plastic dip stick
Figure 1.13
1. If the engine has been run, allow it to cool thoroughly.
Position the unit for easy access to the cylinder head.
2. Disconnect the high-tension lead from the spark plug
and ground it well away from the spark plug hole.
3. Remove the spark plug using a 13/16" or 21mm
wrench. A flexible coupling or "wobbly" extension
may help. See Figure 1.12.
Valve cover
4. Remove the four bolts that secure the valve cover
using a 10mm wrench, and remove the valve cover
from the engine.
NOTE: If care is used not to damage the valve cover gas-
5. Confirm that the piston is at Top-Dead-Center on the
compression stroke.
NOTE: A plastic dip stick makes an excellent probe to find
• The compression stroke can be distinguished
• There is an automatic compression release mech-
ket, it can be re-used.
TDC. See Figure 1.13.
from the overlap stroke by the presence of air
pressure at the spark plug hole and the fact that
neither of the valves should move significantly on
the compression stroke.
anism that "bumps" the exhaust valve as the piston
rises on the compression stroke. At TDC, the
exhaust valve should be fully closed.
Introduction
13