Whirlpool AWO 7120 Instructions For Use Manual page 14

The programme time indicated on the
remaining time display (if fitted) "jumps" up
or down suddenly by several minutes, or the
programme time shown initially is lengthened/
shortened by a period of time:
This is a normal capacity of the washing machine to
adapt to factors that the wash programme time can
have an effect on, e.g.:
Fault description table
Small indicator light is on.
"Water tap closed"
"Clean pump"
-
"Water Stop"
Fault description table for models with LCD display
LCD display
Water Stop Fault
a. Water supply fault
The appliance has no or insufficient water supply.
For models with fault display, the "Water tap
closed" indicator lamp lights up or "FH" flashes on
the display.
For models with LCD display, the display shows:
For models with no fault display, the washing
machine stops in the appropriate programme step.
Stop the appliance and unplug it.
26
Digital display
"FH"
"FP"
from "F15" to
"F19"
"FA"
Start/Pause
button
flashing
up to
flashing
flashing
flashing
• excess foam formation
• load imbalance due to heavy items of laundry
• prolonged heating time due to reduced delivery
of hot water
Because of influences like these, the time remaining
in the programme run is recalculated, and updated
if necessary. In addition, during the filling phase, the
washing machine determines the load and if
necessary adjusts the initial programme time
displayed accordingly.
Fault description
"Water supply fault"
"Draining fault"
"Electrical module fault"
"Water Stop Fault"
Fault description
Water supply fault
Fault in an electrical component
Draining fault
Water Stop Fault
Check whether:
• the water tap is fully open and there is sufficient
water supply pressure
• kinks are present in water hose
• the mesh filters of the water supply are blocked
(see "Care And Maintenance/Mesh filters for
water connection")
• the water hose is frozen up
• the washing machine has a safety hose and the
safety valve is open (red indicator in the safety
valve inspection window); In this case replace it
with a new safety hose
Plug in the appliance once again.
reselect the desidered programme and press the
"On/Off" button.
If the fault occurs again, please contact After-Sales
Service (see "After Sales Service").