Replacing The Batteries; Replacing The Ink Roller; In Case Of Power Failure Or Paper Jam - Sharp XE-A101 Instruction Manual

A101_01(E) 03.9.12 7:28 AM

Replacing the Batteries

This cash register displays a low battery symbol ( ) when the batteries installed get low, and
displays a no battery symbol (
When the low battery symbol is displayed, replace the batteries with new ones as soon as
possible. The existent batteries will be dead in about two days.
When the no battery symbol is displayed, replace the batteries immediately. Otherwise, if the
AC power cord is disconnected or a power failure occurs, all the programmed settings will be reset
to the default settings and any data stored in memory will be cleared.
For replacing the batteries, be sure that the cash register is plugged in and the mode switch is on
the REG position, then replace the batteries with new ones referring to "Install Batteries" section on
page 4.

Replacing the Ink Roller

When printing becomes faded, replace the existing ink roller with a new one available from SHARP.
Precautions:
• Be sure to use an ink roller available from SHARP. The use of
any other ink rollers could cause troubles in the printer. Never
pour ink to the ink roller.
• After opening the parcel, install it soon.
1. Remove the printer cover.
2. Pull the ink roller handle upward to remove the ink roller.
3. Install a new ink roller.
4. Replace the printer cover.

In Case of Power Failure or Paper Jam

When power failure occurs:
If power is lost, the machine retains its memory contents and all information on sales entries when
the batteries are in the proper state of charge.
• When power failure occurs in register idle state or during an entry, the machine returns to the
normal state of operation after power recovery.
• When power failure occurs during a printing cycle, the register prints "············" and then carries
out the correct printing procedure.
When printer motor locks:
If printer motor locks, printing stalls and intermittent beeping starts. First, unplug the power cord
and repair paper jam. Then plug in the power cord, feed the roll paper to the proper position and
press c. The register with then resume correct printing after printing "············"
Page 23
) when batteries are extremely low or batteries are not installed.
Maintenance
Ink roller
23