Advertisement
Turn and Lane Change Si,gnak
The turn signal has two upward
(fat
right) and- two
ciownwa~d (for left) p??sitions. Tbese positions allow
you
to signal a
turn
0.r a.lane. change:
To signal
-a
turn,
move the lever all the way up or down.
When
the turn is finished, the lever will return aut~omatically.
An anow on. the instrume
panel will flash in the
direction of the- turn or
lane change.
If a bulb is: burned.out, replace it.t-o help avoid an
acc.ident.
If
the
arfows
don't
g.0
on
at
all when you
sign-a1 a turn, check the
fuse
( s e e
"Fu-se.s and
Circuit
Breakersl' in the .Ind.ex) and
for burned-oat bulbs.
If you have
n
trailer towing option with -added wiring,
for
the. traiier%mps, a d-ifferent turn :signal flasher is
used.
With this flashes installed, the signal. indicator will flash
even if a.tum signal bulb is burllid
O W .
Check the-ffont
an.d rear turn signal
lamps
-regularly tu
make
sure. they
are working.
Headl-amp High/Low Beam Changer
To change the headlamps from low to high-beam or
high
to
low-beam, pull the multifunction lever all the
way
t.oward you. Then release it.
To signa1 a Lane change, j,ust raise- or lower the. lever
until the arrow starts to flash. Hold it there until you
Complete your lane,c,hangc, The
kevei-
will
return by
itself when you release
it.
As you signal
a turn -or a lane
c,hange, if the armws don't
flash but just
sxay
on, a signal buIb may be burned
Gut
arid other. drivers won't ,see. your turn signal..
When the.'hi.gh-beam
headlamps are on,. this
indicator light
.OM
the
instrument pgniJ
w i l l
dso be on.
. .
2-38
Advertisement
