Advertisement
Finding a Station
AM-FM:
Press the lower knob to switch between, AM
and F M . The display shows your selection.
TUNE:
Turn the lower knob to tune
in
radio stations.
SEEK:
Press this button to go to the next higher station
land stop.
' 1
'SCAN: Press this button to listen to. each station for a
few seconds. The fadio will go to the next station, stop
for a few seconds, then go to the next station. SCAN
will appear on the display. Press SCAN again to
stop scanning.
PUS.HBUTTONS: The four numbered pushbuttons let
you return to your favorite stations. You can set up to
14 stations (seven
A M
and seven FM). Fist:
1. Turn the radio on.
2. Press
AM-FILI
to
select the band.
3. Tune in the desired station.
4. Press SET. (SET will appear on the display.)
5. Press one of the four pushbuttons, within five
seconds. Whenever you press that numbered button,
the station you set will return.
6. Repeat the steps for each pushbutton.
In addition to the-four stations already set, up
to
three
more stations may be preset on each band by pressing.
two adjoining buttons at the same time. Just:
1. Tune in the desired station.
2. Press S-ET. (SET will appear on the display.)
3. Press two adjoining pushbuttons at the same time,
within five seconds. Whenever you press the same
two buttons, the station you set will return.
4. Repeat the steps for each pair of pushbuttons.
Setting the Tone
BASS: Slide this lever up- or down to increase or
decrease bass.
TREBLE: Slide this lever up or down to .increase or
decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
Adjusting the Speakers
BAL: Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between. the speakers.
FADE: Turn the control behind. the lowex knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
3-7
Advertisement
