Advertisement
4. Insrall a new bulb?
3. Remove. the bulb.
and tighten the screws.
If equipment--such
as
a cap or camper is installed
on
your vehicle, a center high-mounted stoplamp feed wire
is
provided
along the driver's
s.iid& rear fram-e. This wire
,-rshould be used to install a center high-mounted
'-stoplanip
in
the cap 'or c.mper;
Taillamps
1
..
Open the tailgate;
2. Re,move the-.screws f r ~ m
the lamp assembly
n e a
the tailgate latch..
3. Pull the assembly away from the pickup side. panel.
4. Turn the socket countexclockwise to remove it. Push
the tab. i-n while you turn the s,ocket.
5.
Pull the bulb out.
,6. Push the
new
bulb into the socket-.
7. Put the scrcket into the assembly and.ttlrn the s:ocket
c l o c k w k until it locks into-place-:
8. Rep1.ac-e-the assembly. Install
and tighten the screws,
-9. Close the tailgate.
6-40
Advertisement
