Remote Engine Start; Starting To Drive - Acura MDX 2016 Owner's Manual

DRIVING

Remote Engine Start*

Start your vehicle's engine from extended distances using the two-way remote
transmitter before you enter the vehicle.
Amber indicator:
remote is
communicating with
vehicle.
ENGINE HOLD button:
After pressing the LoCK
button, press and hold
to start the engine.
LOCK button
Make sure the vehicle is in a safe location when using remote engine start (i.e., a
well ventilated area, away from any flammable materials).
Starting the Engine
Press the LoCK button, then press and hold the eNGINe HoLD button to
remotely start the engine.
The engine runs for up to 10 minutes. To extend the run time for another
10 minutes, repeat the procedure during the initial 10 minutes.
While the engine is running, the climate control system adjusts the cabin
temperature, the security system remains on, and lights and accessories remain off.
Stopping the Engine
Press and hold eNGINe.
The engine will also stop if it has been running for more than 10 minutes, or if any
door is opened without using the remote or keyless access.
WARNING
engine exhaust contains toxic carbon monoxide gas.
Breathing carbon monoxide can kill you or cause unconsciousness.
Never use the remote engine starter when the vehicle is parked in a garage or
other area with limited ventilation.
92 |
Green indicator:
Confirms doors are
locked or engine is
running.
Red indicator:
remote is out of
range or cannot
communicate with
the vehicle, or engine
is stopped.
*if equipped

Starting to Drive

The keyless access system allows simple push-button start.
Before Starting the Engine
Make sure the gear is in Park (P) and the parking
brake is released, then depress the brake pedal.
Keep your foot firmly on the brake pedal when
starting the engine.
The engine is harder to start in cold weather and
in thinner air found at altitudes above 8,000
feet (2,400 m). When starting the engine in cold
weather, turn off all electrical accessories such
as the lights, climate control system, and rear
defogger in order to reduce battery drain.
Changing the Power Mode
Accessory or On Mode: Press eNGINe STArT/
SToP once without pressing the brake pedal for
Accessory mode. Press it again for on mode.
Starting the engine: Press and hold the brake
pedal, then press eNGINe STArT/SToP. Keep your
foot firmly on the brake pedal when starting the
engine.
Turning the vehicle off: Change the gear to Park (P), then press eNGINe STArT/
SToP. If you press the button and the gear is not in Park, the vehicle goes into
Accessory mode.
DRIVING
Brake pedal
| 93