Operating Mode Selector Switch
FW mode: Firmware update mode
Move the switch to the OP position after the upgrade is complete.
OP mode: Firmware operation mode
In the WF-2000, the switch is always in the OP position. Only when updating the WF-
2000 firmware, the switch can be moved from the OP position to the FW position.
Table 2-3 Power/Signal Connector
Power/Signal connector
Pin Assignment
F.G
+Vs
GND
RxD
TxD
2.3
Dimensions
The diagrams below provide the dimensions of the WF-2000 to use in
defining your enclosure specifications. All dimensions are in millimeters.
Figure 2-7 Front / Left Side dimension of the WF-2017/WF-2026
WF-2000 Series AIO
User's Manual (Ver. 1.2, May./2014) ------------- 15
Description
Frame Ground
+10 ~ +30 VDC
Power / RS-232 GND
RS-232 RxD
RS-232 TxD