Overview
The characteristics that determine the way your phone
operates in the Cellular System are determined by the
Scanning Mode programmed for your phone.
Reviewing / Changing Scanning Mode
Typically, the scanning mode for your phone is
programmed by your Service Provider. However, you may
review the current scanning mode and (if desired) change
it by following these procedures.
To Review Scanning Mode
1. Press
,
RCL
active system choice.
2. Press
END
To Change Scanning Modes
1. Press
,
RCL
active system choice.
2. Repeatedly press
scanning modes.
3. When the desired scan setting appears in the display,
press
.
STO
4. Press
END
NOTE Constant flashing of RM, or a steadily lit NS while
within your home service area may indicate an
unintentional choice has been made. If this occurs, review
the System Type to see if the unit is operating in Standard
Mode, or if an alternate selection has been made.
Programming Scanning Modes
. The display will show the current
to exit without changing selections.
. The display will show the current
or
to exit to normal operation.
to cycle through the
45